![]() If stereo signals from Pro Tools (or any other source) are sent to Main or Surround inputs 1 & 2 (rather than 1 & 5) then only the left side of the the headphones will receive a signal. while the Main and Surround inputs are in 7.1 Surround configuration where 1 is Left and 5 is Right. The XMON Cue inputs are in stereo pairs: 1/2, 3/4, etc. The headphones are either fed by the Cue Inputs or the Main Monitor source (as selected in the Monitoring section). Using the 2nd output card described in step #1 above, you would choose the DA card's 3 + 4 outputs for Cue 1, 5 + 6 for Cue 2, 7 + 8 for Cue 3).ĥ) Adjust the individual track send levels to assemble the Cue 1 Mix. Indicates where to display the user interface window. In particular -display displayname:displaynumber. English Deutsch Français Español Português Italiano Român Nederlands Latina Dansk Svenska Norsk Magyar Bahasa Indonesia Türkçe Suomi Latvian Lithuanian esk. Set the Sends to the corresponding interface outputs ( I.E. Xmonui accepts all of the standard X Toolkit command line options. D-Command Guide v8.0 (PDF) - Advanced Audio. Will be professionally packed for shipment. Instructions are available on the Avid forum. You can make your own from a db-15 printer cable. ![]() Repeat above steps for Cue 2 and Cue 3.Ĥ) In Pro Tools, insert a send on tracks you want to include in your Cue mix. LED power supply (weak link on these) was just rebuilt so good to go XMON included but no cable. Select Cue in 1 to send the Cue 1 inputs to the Cue 1 outputs or choose Main Mon to send the Control Room monitor mix to the Cue 1 outputs. D-Command monitoring is based on the XMON analog interface, which is remotely controlled from the D-Command. Touch the Cue 1 encoder in the D-Control Monitor Section. (not included), and attach the control lead from the XMON to the D-Control or D-Command Main Unit. A 50-foot (15.25 m) cable is included with the D-Command Main Unit. On the back of XMON are four D-Sub connectors for inputs. XMON back panel XMON Monitoring System Connection D-Command connects to XMON with a single 15-pin XMON cable. The Cue Output pin outs are as follows: (for more information on XMON pin outs see Appendix B of the D-Control manual) Digidesigns D-Command and D-Control represent perhaps the most ambitious attempt yet to integrate recording and mixing systems. An additional 192 I/O +4 analog connector (from another 192 I/O or D to A expansion in the primary unit) should be connected to the XMON's Cue Input connector.Ģ) Connect the XMON's Cue Output connector to your headphone distribution amplifier or mixer. Problems: The XMON has been automatically muting its monitor section, it appears on the D-Command status 'XMON OFF'. The primary 192 I/O's analog D-Sub connector should be connected to the XMON's Main Input connector. 18V phantom power for the Talkback 2 Mic that connects via the DB-25 connector. 6-channel control room monitoring system supports mono through 5.How do I set up cue mixes with D-Control?ġ) You'll need at least two 192 I/O analog output cards available in your configuration. To learn how to use XMON with Avid D-Control or D-Command work surfaces.Full transport and navigation controls, including location commands and scrub/shuttle capability.The system supports up to an 80-foot (24.5 m) cable. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |